GE WD18X10049 Dishwasher Sump Inlet - Part

GE WD18X10049 Dishwasher Sump Inlet

Genuine OEM GE WD18X10049 sump inlet for GE and Hotpoint dishwashers. The sump inlet directs water from the wash tub into the sump area where the pump circulates it through the spray arms. A cracked, damaged, or clogged sump inlet can cause poor wash performance, water not draining properly, or leaks beneath the dishwasher.

Key Features

• Genuine OEM GE replacement part
• Directs water flow from tub to sump and pump
• Ensures proper water circulation during wash cycles
• Durable plastic construction
• Direct fit for compatible GE and Hotpoint dishwashers

Common Symptoms This Part Fixes

• Dishes not getting clean
• Water not draining from dishwasher
• Water leaking under the unit
• Low water pressure in spray arms
• Cracked or damaged sump inlet

Installation

Turn off power and water supply to the dishwasher. Remove the lower spray arm and the lower dish rack. Remove the sump cover or filter assembly to access the sump inlet. Disconnect the old inlet and remove it. Install the new sump inlet in the same position. Reassemble the filter, spray arm, and dish rack. Restore power and water, then run a test cycle.

WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov