Washer Suspension Rod Assembly 24 Inch WH16X27182

Genuine GE Washer Suspension Rod Assembly WH16X27182

GE WH16X27182 is listed as a suspension rod assembly for top-load washers. Match the manufacturer's specified rod and mounting position to your washer's complete model before ordering.

Product Details

• Manufacturer: GE
• Part number: WH16X27182
• Catalog-listed length: 24 inches
• Part type: washer suspension rod assembly

Compatibility

Verify the complete washer model, specified rod position and mounting requirements. Length alone does not establish compatibility. Do not assume a complete suspension set or extra retainers are included.

Diagnostic Considerations

Excessive vibration, banging or tub movement can indicate suspension wear, but loading, leveling, mounting and other damaged components can cause similar symptoms. Diagnose the washer before replacing parts. Replacement does not guarantee elimination of vibration or noise.

Installation and Safety

Disconnect power and isolate the water supply before service. Follow exact-model access instructions; no universal front or rear panel procedure is assumed. Safely support the tub before releasing a suspension rod, and do not rely solely on the remaining rods to support it.

Use the manufacturer's specified mounting points, orientation and retainers. Inspect other suspension components and replace them only as directed by the service instructions and diagnosis. Restore panels and utilities, check for leaks where applicable and perform prescribed operational checks. Use qualified service if safe access or tub support is uncertain.

WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.