Whirlpool 2314156 Refrigerator Defrost Timer Adaptive Defrost Control | Replaces WP2314156

Whirlpool Refrigerator Defrost Control 2314156 / WP2314156

This refrigerator defrost control is catalog-listed under 2314156 and WP2314156. Replace it when model-specific diagnosis confirms the control is responsible for a defrost-cycle fault. It is not a defrost heater or thermostat. Confirm the required control and revision before ordering.

Technical Specifications

Fixes These Symptoms

• Defrost cycle does not operate correctly because of a confirmed control fault.
• Evaporator frost buildup traced to a diagnosed defrost-control malfunction.
• Cooling interruption associated with a confirmed defrost-control fault.

These symptoms alone do not establish control failure. Check related heater, thermostat, wiring and airflow faults per the appliance service sheet. No heating, dispensing or unrelated error-code repair is claimed.

Key Product Benefits

• Replacement for the matching refrigerator defrost control.
• Both existing catalog identifiers retained for model-specific comparison.

Compatibility & Part Numbers

Preserved catalog identifiers: WP2314156, 2314156. Confirm the required revision; no replacement direction is implied.

Catalog-listed brands: Whirlpool, Kenmore, KitchenAid, Roper, Estate, Maytag, Amana, Admiral, Magic Chef, Norge, Jenn-Air/JennAir and Sears. Brand names do not establish model-wide fitment.

Verify WP2314156 fit using the full appliance model number.

Control construction, timing, electrical ratings, terminal configuration and any setup requirements need model-specific verification.

Step-by-Step Installation Instructions

Unplug refrigerator and verify power is disconnected. Protect stored food. Follow the model-specific service sheet; use a qualified technician if diagnosis or wiring is unfamiliar.

1. Confirm full model, specified control revision and diagnosed fault.
2. Disconnect power and access the defrost control per the manual.
3. Photograph wiring and note mounting orientation.
4. Release hardware and connectors without pulling wires.
5. Install the matching control and connect exactly as the service sheet specifies. Follow setup instructions only if required for the model.
6. Refit covers before restoring power and checking cooling/defrost operation per service instructions.