Washer O-Ring Seal For: Whirlpool W10072840 ERW10072840

Washer O-Ring Seal – Whirlpool

The ERP ERW10072840 o-ring seal helps seal the washer’s agitator inner cap area in compatible Whirlpool applications. A worn or deteriorated seal can allow leakage. This aftermarket replacement is supplied by ERP for compatible Whirlpool washers.

Compatible Part Numbers

• ERW10072840
• W10072840

Compatible Models

Fits various models. Please verify compatibility with us before ordering

Key Features

• Direct replacement: Aftermarket replacement for compatible Whirlpool washer applications.
• Primary function: Forms a seal at the agitator inner cap area.
• Key benefit: Helps address leakage caused by a worn or deteriorated o-ring.
• Installation ease: Match the original seal location and fit without forcing or stretching the replacement.

Fixes These Symptoms

• Leakage around the agitator inner cap area
• Visible o-ring wear or deterioration
• Seal is cracked, flattened, or damaged
• Water reaches an area that should remain sealed

Compatible Brands

• Whirlpool

Product Details

• Part type: Washer o-ring seal
• Application: Agitator inner cap seal
• Primary part number: ERW10072840
• Replacement type: ERP aftermarket

Installation Instructions

Confirm the complete appliance model and original part number before installation. Disconnect electrical power and follow the model-specific service instructions. Shut off the water supply where applicable, remove the original seal without damaging the sealing surface, fit the replacement in the same location without forcing or stretching it, reassemble, restore utilities, and check for leakage during a supervised test.

For cleaning and washer-care products, see affresh.

Always verify your model number before ordering. Check the label inside the washer to confirm compatibility.

California Proposition 65: WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov

ERP is an aftermarket supplier. This is not an OEM-manufactured part. Original equipment names and numbers are used only to identify compatible applications.