Whirlpool Washer Seal 3976308 WP3976308

Washer Seal – Whirlpool

Whirlpool Washer Seal 3976308 WP3976308 This washer seal seals the designated opening or drum edge to control airflow, heat, moisture, vibration, or contact between moving surfaces. It is intended as a model-specific replacement for the service part listed below. Confirm the complete appliance model and serial number before ordering. Part-Specific Details OEM Whirlpool WP3976308 Tub Ring Seal 3976308 Product Specifications Brand: Whirlpool Primary SKU: 3976308 Product type: Washer Seal Application: model-specific washer repair Match profile, length, material, adhesive requirement, seam location, and mounting channel Clean the mating surface completely and inspect adjacent guides or bearings Replaces / Cross-Reference Part Numbers 3976308, WP3976308 Cross-reference numbers can identify earlier revisions, distributor references, or approved service replacements. Compatibility can vary by production date and model revision. Symptoms of Failure Air, heat, moisture, or lint leakage clothes snagging scraping or thumping loose or torn felt visible gap, wear, or adhesive failure Installation Instructions Disconnect power and shut off gas when applicable. Access the seal, record its seam and orientation, remove old material and adhesive residue, clean and dry the surface, apply the specified adhesive where required, seat the replacement evenly without stretching, allow full curing time, rotate the drum or door by hand, then reassemble and test. Compatibility and Safety Confirm fit using the appliance rating label and Whirlpool-family parts diagram. Disconnect power and shut off water or gas when applicable, wear suitable protective equipment, preserve all shields and guards, and use a qualified technician for gas-system work or unfamiliar electrical repairs.

Compatible Part Numbers

• 3976308
• WP3976308

Key Features

• Product type: Washer Seal
• SKU / MPN: 3976308

Fixes These Symptoms

• Air
• heat
• moisture
• or lint leakage
• clothes snagging
• scraping or thumping
• loose or torn felt
• visible gap
• wear
• or adhesive failure

Compatible Brands

• Whirlpool

Always verify your complete appliance model number before ordering.

Installation Guidance

Disconnect power and shut off gas when applicable. Access the seal, record its seam and orientation, remove old material and adhesive residue, clean and dry the surface, apply the specified adhesive where required, seat the replacement evenly without stretching, allow full curing time, rotate the drum or door by hand, then reassemble and test.