Dishwasher Drain Pump For: Whirlpool W10348269 WPW10348269 AP6020066 PS11753379 ERW10348269

Dishwasher Drain Pump – Whirlpool

Replace a failed dishwasher drain pump that leaves standing water in the tub or causes slow draining, unusual pump noise, or a drain error. This direct replacement helps restore proper wastewater removal at the end of each cycle.

Compatible Part Numbers

• W10348269
• WPW10348269
• AP6020066
• PS11753379
• ERW10348269

Key Features

• Direct part-number replacement: Replaces the Whirlpool W10348269 dishwasher drain pump application.
• Primary function: Pushes wastewater out of the dishwasher at the end of each phase.
• Key benefit: Helps clear standing water and restore normal draining when the original pump is jammed or worn.
• Installation ease: Twists into the pump housing with the standard wiring connection; follow the service instructions.

Fixes These Symptoms

• Water remains in the tub after the cycle ends
• Dishwasher drains slowly or not at all
• Humming, grinding, or buzzing during the drain stage
• Drain error or fault code is displayed

Compatible Brands

• Whirlpool

Compatible Models

• 66513223N412

Installation Instructions

1. Disconnect power and remove standing water from the tub.
2. Access the pump following the manufacturer’s service instructions.
3. Note the wire positions and disconnect the pump wiring.
4. Remove the old pump, clear debris from the housing, and install the replacement.
5. Reconnect wiring, reassemble, and run a supervised drain test.

If you are not comfortable performing this installation, contact a qualified appliance service technician.

For routine dishwasher care, see affresh.

Always verify your complete dishwasher model number before ordering. Check the model label on the appliance to confirm compatibility.