ERP TH10104 Refrigerator Temperature Sensor | Replaces DA32-10104A, DA32-10104N, DA32-10104V

Refrigerator Temperature Sensor – ERP

ERP TH10104 refrigerator temperature sensor is a Supco replacement sensor designed for compatible Samsung refrigerators. It monitors compartment temperature and reports it to the electronic control so the appliance can maintain the selected temperature. Product specifications Brand: ERP / Supco Part number: TH10104 Length: approximately 10 inches Application: domestic refrigerator temperature sensing Replaces: DA32-10104A, DA32-10104N, DA32-10104V Condition: new replacement part Symptoms of failure Incorrect or fluctuating refrigerator temperature, excessive cooling, insufficient cooling, repeated compressor cycling, temperature-related error codes, or a sensor reading that is open, shorted, or out of range. Installation instructions Disconnect refrigerator power. Locate the original sensor in the appropriate compartment or evaporator area, document the wire routing and connector orientation, remove covers carefully, install the replacement in the same position, secure the wiring away from fans and sharp edges, reinstall all covers, and confirm normal temperature operation after power is restored. Compatibility and safety Verify the appliance model and original sensor number before ordering. Similar sensors can use different resistance curves or connectors and may not interchange.

Compatible Part Numbers

• TH10104
• DA32-10104A
• DA32-10104N
• DA32-10104V

Key Features

• Product type: Refrigerator Temperature Sensor
• SKU / MPN: TH10104

Fixes These Symptoms

• Incorrect or unstable refrigerator temperature
• overcooling or insufficient cooling
• frequent compressor cycling
• temperature error codes
• open
• shorted
• or out-of-range sensor readings.

Compatible Brands

• ERP
• GENERIC REPLACEMENT PART

Always verify your complete appliance model number before ordering.

Installation Guidance

Disconnect power. Access the original temperature sensor, document wiring and routing, install the new sensor in the identical position and orientation, secure wiring away from moving or sharp components, replace covers, restore power, and monitor temperature operation.