ERP ERSET410 Dryer Thermal Fuse | Replaces WP3399849, AP6008376, PS11741511, 3399849

Dryer Thermal Fuse For: Whirlpool Amana Jenn Air Kenmore Magic Chef Maytag

The SET410 196°F single-blow dryer thermal fuse helps protect the thermal circuit in compatible Whirlpool-built dryers. When the fuse opens, the dryer may stop operating. It uses 1/4-inch spade terminals and welded construction for the current-carrying connection. This is a direct replacement for the verified part numbers listed below.

Compatible Part Numbers

• 3399849
• WP3399849
• AP6008376
• PS11741511
• SET410

Key Features

• Direct replacement: Replaces the verified 3399849 dryer thermal fuse references.
• Primary function: Helps interrupt the thermal circuit when the dryer reaches an unsafe heat condition.
• Key benefit: Can restore dryer operation when the original fuse has opened.
• Installation ease: Uses 1/4-inch spade terminals and installs in the original location after power is disconnected.

Fixes These Symptoms

• Dryer stops operating
• Original thermal fuse has failed or opened
• Thermal-protection circuit is interrupted
• Fuse shows damage after an overheat condition

Compatible Brands

• Whirlpool
• Amana
• Jenn Air
• Kenmore
• Magic Chef
• Maytag

Compatible Models

Designed for specific Whirlpool-built dryer models, including selected Amana, Jenn Air, Kenmore, Magic Chef, and Maytag models. Please verify the complete appliance model and original part number before ordering.

Installation Instructions

Disconnect electrical power before servicing. Investigate the cause of overheating, photograph or label the connections, remove the original fuse, install the replacement in the same position and orientation, reinstall all guards, and perform a supervised test. Use a qualified technician for electrical service.

ERP replacement part. Confirm the full appliance model and original part number before ordering.